Home > News > Bearings Care >

2020 Complete Analysis on What Damage Rolling Bearing [Quick]

News Group

2020 Complete Analysis on What Damage Rolling Bearing [Quick]

Issue Time:2019-09-12

2020 Complete Analysis on What Damage Rolling Bearing [Quick]

Roller bearing

There is research on the manufacture and production of rolling bearings. It proved that only one percent should fail to reach their full-service life expectancy. That’s a very small percentage, which also proves that if your ball bearings fail, there must be a very good reason. Determining the reason for ball bearing failure can prevent future failures.  And provide essential information for proper planning and maintenance. Below is the analysis of what damage rolling bearing. 

Luckily, experience has shown that ball bearings fail for only a handful of very specific reasons. So, make sure you’re familiar with these principle causes. You’ll save your company from a host of unfortunate consequences. This includes increased downtime, replacement costs, operating efficiency, damage to machinery and, in the worst case, injured employees.

Improper Lubrication

Lubrication is vital to limit friction and extend a bearing’s service life. Improper lubrication is the number one cause of bearing failures. So this is the first thing you need to check. Failures are often the result of using too little or too much lubricant. Use the incorrect lubricant or contaminated lubricant is also a problem. The use of mixed lubricants that are incompatible would cause bearing failure. As well as following the wrong lubrication interval specifications.

Make sure you follow the bearing manufacturer’s instructions for proper care and maintenance. These guidelines not only ensure your warranty stays valid, but they also provide information on how to store, handle and inspect your lubricants. Many people assume that one lubricant will work for every application, but this is hardly ever the case. Investing in the correct lubricants is an investment in your machinery in the long run.

Incorrect Rolling Bearing Installation

Even the smallest contaminant, dent or scratch can severely reduce the life of your ball bearings, which is why mounting and installing bearings is a job that requires skill and the use of proper tools. Make sure your maintenance staff has rich experience on how to correctly handle, remove and install bearings. It’s also important that prior to installation, store your bearings according to the manufacturer’s careful specifications.

Overloading

People design every bearing with a particular limit for load, speed, and temperature. If these factors exceed the limits, the bearing can suffer from irreparable damage. Overloading is often the result of operational changes and stresses, or operator error. The first sign of overloading is an unusual noise or increased temperature within the application. If your bearings accidentally overloaded, make sure to replace them rather than risk further damage.

These are the three main causes of ball bearing failure, but as you can see, each issue can be easily overcome with proper care and foresight. Understanding how to prevent ball bearing failure will ensure you get the maximum life out of your parts, saving you plenty of money and production time.