Home > News > Bearings Care >

Tips on How to Choose Shaft And Bearing Housing Fits [Quick]

News Group
Tips on How to Choose Shaft And Bearing Housing Fits [Quick]
Issue Time:2019-07-12

Tips on How to Choose Shaft And Bearing Housing Fits [Quick]

bearing housing fits

Choosing the Best Fit between the Bearing & Shaft, or Bearing Housing Fits

Planning for proper bearing fit between the ball bearing and the shaft or housing is as important as bearing design and cleanliness. Improper bearing fits or incorrect installation can damage the bearing assembly. 

This guide is for establishing shaft and bearing fits for miniature and instrument bearings. When the expansion coefficients of the shaft and housing are similar. Or when the operating temperature differential between them is nominal. In other conditions, you should have a modification in fits and internal clearance. 

Some Tips:

  • Use the assembled mechanism, the fit of the ball bearing on its mating components is vital to maximizing bearing life
  • If the fit is too loose, the bearings slide around on the shaft, eliminating the advantages gained by selecting a ball bearing in the first place. 
  • When the fit is too tight, the bearing integrity may be compromised by the reduction of radial play in the assembly. 
  • Perfect fit enables bearings to run at peak performance for maximized end-product life. 
  • There are three main types of shaft and housing fits. 
  1. Loose fit is when the bore of the inner ring is slightly larger than the outer shaft diameter. 
  2. A line-to-line assembly is when the bore of the inner ring of the bearing and the shaft outer diameter are the same. 
  3. With a tight fit, the bore of the inner ring of the bearing is slightly smaller than the outer shaft diameter. Tight fits are interference or press fits. Because bearings in these assemblies are pressed onto shafts.
  • Slightly loose shaft-to-housing fits are suitable for most applications, while line-to-line fits often provide the best performance. 
  • If assemble bearings on a shaft that is too large (creating a press fit) the inner ring may stretch slightly. When this occurs, the bearing’s radial play can be diminished or even eliminated altogether.